Firing Rate / Modulation
Modulation level and current input. Simulated.
- Firing Rate
- 0 % (sim)
- Modulation
- 0 % (sim)
- Input
- 0.00 MMBTU/h (sim)
- Stage
- Off
BAS Operator Drilldown
B-2 · High-efficiency condensing
Read-only / advisory
No BAS writes
Simulated values (sim)
Role: LAG
Flame: NOT PROVEN
Alarm active
Lockouts: 1 open / 2 recent
Standby
0 % rated input (sim)
Flame / Combustion
Flame proof and combustion air state. Simulated.
- Flame Status
- Not proven
- Flame Signal
- 0.0 µA (sim)
- Combustion Air
- Not proven
- Ignition Attempts
- 3 of 3 (sim)
Stack / Flue
Stack temperature, flue draft, and combustion analyzer values. Simulated.
- Stack Temp
- 82 °F (sim)
- Flue Draft
- −0.00 in.wc (sim)
- O₂
- —
- CO
- —
HWS / HWR Context
Plant-side hot-water context this boiler serves. Simulated.
- HWS Temp
- 152.7 °F (sim)
- HWS Setpoint
- 150.0 °F (sim)
- HWR Temp
- 129.3 °F (sim)
- Delta-T
- —
- Differential Pressure
- 9.8 psid (sim)
Lead / Lag Rotation
Read-only role display. Rotation is governed by plant logic; no BAS writes from this page.
- Current Role
- LAG
- Rotation Note
- Lag standby — auto-start on HWS deviation > 5°F (sim)
- Runtime
- 11,562 h (sim)
- Mode
- Standby
Other boilers in plant:
Lockout History / Status
Recent lockouts and trips. Open (manual reset required) listed first. Simulated.
- 2026-05-09 08:51 LK-31 · Low water cutoff trip — manual reset required OPEN
- 2026-05-04 14:09 LK-15 · Combustion air proving switch lost Auto-reset
Point / Detail Navigation
Drill into a specific point or related operator surface. Unresolved kinds render as disabled hint chips.
- firing_rate → point_detail (not yet routed)
- flame_signal → point_detail (not yet routed)
- stack_temp → point_detail (not yet routed)
- trends → trends (not yet routed)
- alarms → alarms (not yet routed)
- plant → hot_water_plant
Operator Notes
Locked out: low water cutoff trip not auto-reset; manual intervention required.
- Firing rate plus flame status answers the first heating-side question instantly: is this boiler producing heat right now?
- Stack temp + O₂/CO give a fast read on combustion health and condensing efficiency.
- HWS/HWR/Δ-T pair ties the boiler back to the plant-level setpoint tracking question.
- Lead/lag role is shown read-only here; rotation is plant-policy, not commanded from this page.
- Lockout history surfaces both auto-reset events and OPEN trips that still require manual intervention.